Dongguan International Technology Transfer Center, 124 Dongbao Road, Dongcheng District, Dongguan, China
Request a quote
Centron Engineering News & Articles

Screw Tip Selection for Engineering Resins

NEWS

The screw tip is the last place the melt passes before the nozzle, and it is where shot-to-shot repeatability is won or lost. The design has to match the resin's viscosity and the machine's shot size.

Three common designs

Free-flow tip

No check valve at all. Simple, cheap, easy to clean, and completely dependent on screw suck-back to stop the flow. Used for high viscosity resins where backflow is slow anyway, and for small machines where a valve would add too much length.

Ball check tip

A steel or ceramic ball seats against a hardened seat during injection. Fast response, good for small shot sizes and low viscosity resins. The trade-off is wear on the seat and the risk of the ball sticking with tacky or glass-filled materials.

Sliding ring (non-return) tip

A ring slides on a mandrel and seals against a seat. This is the default for general purpose and engineering resins because it handles higher pressures and gives good repeatability. Wear shows as a polished ring face and a scored seat, which produces exactly the symptom people blame on the screw: falling cushion and drifting part weight.

Matching to the resin

  • PA, PBT, POM: sliding ring with a hardened seat; these resins are abrasive when filled and thin when hot
  • PC, PC/ABS: sliding ring, generous flow path, avoid sharp corners that hold degraded material
  • PPS, PEEK: high temperature alloy tip, tight clearance, often a bimetallic assembly
  • PVC: free-flow or specially designed tip; stagnant areas cause burning and corrosion
  • Small shots under 20 g: ball check for fast response

Maintenance reality

A tip and ring assembly is a wear item. Check the ring seat every time the screw is pulled, and replace the ring before it becomes a ring plus mandrel plus seat. It is one of the cheapest parts on the machine and one of the most common causes of a drifting process.

See screw tip assemblies and screws.