Dongguan International Technology Transfer Center, 124 Dongbao Road, Dongcheng District, Dongguan, China
Request a quote
About Centron

We make the wear parts that decide your part quality.

Centron designs and machines injection molding screws, barrels and front-end components in Dongguan, China. Our work sits inside other people's machines — which is exactly why it has to be right.

Centron manufactures injection molding screws, barrels, screw tip assemblies and nozzle bodies. The work is carried out in Dongguan, Guangdong, and shipped to molding shops, machine builders and repair services that need a component matched to a machine that already exists.

Working from the machine, not the catalogue

Most of what leaves our floor is a replacement part or a matched screw-and-barrel set. That changes how the job starts: with the press model, the worn component or a drawing, and a conversation about what the part actually has to survive. Diameter, L/D ratio, flight geometry, alloy and surface treatment are agreed in writing before any steel is cut.

Product scope

  • Screws — general purpose, barrier and mixing geometries for commodity, engineering and filled resins.
  • Barrels — bored and finished to match the screw they will run with, including feed zone and heater band arrangement.
  • Screw tip assemblies — tips, non-return rings and seals that hold the shot under injection pressure.
  • Nozzle bodies and tips — the final section of the melt path, where temperature and surface finish affect part quality directly.

How an order runs

  1. You send the machine model, the existing component or the drawing, plus the resin you run.
  2. We confirm geometry, material and surface treatment in writing, and quote against that specification.
  3. Machining, then dimensional inspection of bore, diameter, runout and surface against the agreed drawing.
  4. Packing and shipment, with the inspection record for the batch.

What we are careful about

Wear in an injection unit is rarely a single-cause problem. A screw that is hard but badly matched to an abrasive compound will fail as quickly as a soft one, and a barrel that is not aligned to its screw will wipe the flight clearance long before the steel is worn out. We would rather spend an extra exchange of drawings at the start than replace a part twice.

If you are unsure what you need, send a photograph of the failed component and the process conditions. We will tell you what usually causes that failure mode before we quote anything.

How we work

A component is only as good as the last measurement.

01

Specification first

We start from the machine drawing, the existing part or the resin data — not from a stock catalogue. Geometry is agreed in writing before machining starts.

02

Material matched to wear

Glass-filled, corrosive and commodity resins attack steel differently. Alloy and surface treatment follow that profile, not a default grade.

03

Checked before packing

Bore, diameter, runout and surface condition are verified against the drawing. Anything that does not measure up does not ship.

Working on a replacement or a new build?

Send us the drawing or the worn part. We will tell you what is practical to make and what it will cost.