Dongguan International Technology Transfer Center, 124 Dongbao Road, Dongcheng District, Dongguan, China
Request a quote
Injection Molding Screw Tips - Types and Fit
Screw Tip Assemblies

Injection Molding Screw Tips - Types and Fit

Screw tip assemblies for injection units: tips, non-return rings, seats and seal rings, matched to the screw end and the resin.

Made to your drawing, sample or part number

Machined to your barrel dimensions and screw geometry — no catalogue constraints. Single replacement part or production batch.

Quoted to confirmed specs

Engineering review Monday to Saturday. Send the machine model, screw diameter and resin — the reply carries price, material grade and lead time.

Email engineering

No drawing on file? Send a photo of the worn part and the machine model — we work the geometry back and confirm it with you before machining.

Details

Specification & application

The screw tip is a small part with a large job: it has to seal against back-flow during injection, then open cleanly during recovery. When it stops sealing, the symptom is a cushion that will not hold and parts that vary in weight from shot to shot.

Tips are matched to the screw end and to the resin. A free-flow tip is fine for a commodity grade and wrong for a low-viscosity engineering resin that will run past it.

Types

TypeHow it sealsUse it for
Free-flowNo check element; relies on melt viscosity and screw geometryCommodity PE, PP, PS where a small back-flow is tolerable
Non-return ringA sliding ring seats against a shoulder on the forward strokeThe general-purpose choice for engineering resins; simple and repairable
Ball checkA ball seats in a conical seatLow-viscosity resins that would slip past a ring; needs a clean melt
Sliding ring, heavy dutyRing with a hardened seat and a longer guideFilled and abrasive compounds, high back-pressure settings

Why they fail

  • The seat wears and the ring no longer closes flat. Back-flow rises gradually, so the cushion drifts and nobody notices until weights are out of tolerance.
  • Filler erosion on the ring OD and the seat — a glass-filled grade will open the clearance in a way an unfilled grade never will.
  • Wrong tip for the resin. A free-flow tip on a low-viscosity grade leaks from the day it is fitted.

What to check before ordering

  • Screw end thread and the tip-to-screw interface — these vary between machine builders.
  • Ring OD against the barrel bore; too much clearance and the tip cannot seal.
  • Resin viscosity and filler content, which decide ring material and hardness.
  • Whether the screw end itself is worn. A new tip on a worn screw end will not restore the cushion.

Tip dimensions are matched to the screw end you send or draw. The type selection above is the starting point for that conversation, not a stock list.

Related

Other components in this range

View category

Need this part matched to your press?

Send the machine model and the resin. We confirm geometry, material and surface treatment before quoting.

Injection Molding Screw Tips - Types and Fit Quoted to confirmed specs