Purging Compound Best Practices for Color Changes

Purging is usually done by feel, which is why it consumes more material than it needs to and still leaves streaks in the first parts.
The procedure that works
- Purge at the outgoing resin's temperature, not the incoming one. The material you are removing has to be soft enough to move.
- Empty the hopper and run the screw until the shot starts to starve.
- Add purging compound at roughly the barrel capacity, no more. Extra compound does not clean better; it just costs more.
- Low back pressure, moderate screw speed. High speed smears the compound rather than scrubbing the flights.
- Allow dwell for chemical grades — 5 to 15 minutes with the screw forward.
- Purge with full strokes until the slug is uniform. Look at the slug, not just the color of the surface.
- Introduce the new resin and purge one more barrel capacity before production.
Judging cleanliness
A purge slug that looks clean on the outside can still carry a stripe of the old color inside. Cut the slug lengthways. If the core is uniform, the barrel is clean; if there is a spiral stripe, keep going. This single check prevents most first-shot rejections.
Reducing purging waste
- Plan color changes in sequence, light to dark, so one purge serves two changes
- Keep a dedicated purge grade for hot runners; standard compound leaves residue in drops
- Record the actual quantity used per change and set a target; most shops can halve it
- Do not use production resin as a purge unless the colors are compatible — it is the most expensive option
- For black-to-natural changes, a mechanical compound followed by a small chemical dose works better than either alone
See the purging compound range and cleaners.