Dongguan International Technology Transfer Center, 124 Dongbao Road, Dongcheng District, Dongguan, China
Request a quote
Mica Nozzle Band Heaters — Specifications
Mica Nozzle Band Heaters

Mica Nozzle Band Heaters — Specifications

Mica nozzle band heaters for injection molding machines: 25-160 mm ID, 3-6 W/cm2, up to 480 C, 304 stainless sheath, optional J or K thermocouple.

Sourced to the machine you actually run

Give us the machine model, tonnage or the space it has to fit. We confirm the exact unit, controls and options before quoting.

Quoted to confirmed specs

Engineering review Monday to Saturday. Send the machine model and the output you need — the reply carries price, scope and delivery.

Email engineering

Not sure which size fits? Send the machine model or a photo of the existing unit and we will match it.

Details

Specification & application

Mica nozzle band heaters clamp around the injection nozzle to hold melt temperature between the barrel and the mold. The mica core insulates a nickel-chromium resistance ribbon, and the stainless steel sheath protects it from resin drool, purging compound and repeated clamp-on cycles. This is the workhorse heater for general-purpose resins where the nozzle runs below roughly 400 C.

Standard specifications

ParameterTypical range
Inside diameter25 mm - 160 mm (custom to 400 mm)
Band width25 mm - 80 mm
Voltage220 V / 380 V, single or three phase
Watt density3 - 6 W/cm²
Maximum sheath temperature480 °C (900 °F)
Sheath material304 stainless steel, optional 321
InsulationMica board and mica paper
Lead wire300 - 1000 mm, fiberglass or ceramic bead
Sensor (optional)Type J or K thermocouple, grounded or ungrounded

Where these heaters are used

  • Injection molding nozzles on 30 - 3000 ton machines
  • Hot runner manifolds and drops
  • Extrusion die heads and adaptors
  • Blow molding parison heads
  • Replacement for OEM part numbers on Haitian, Chen Hsong, Engel, Arburg and Sumitomo machines

How to specify the right band

Three dimensions decide fit: the nozzle outside diameter, the band width that clears the mold sprue bushing, and the terminal position. Measure the nozzle OD with a caliper rather than guessing from the machine tonnage. Wattage then follows the heated area — roughly 4 W/cm² is a safe starting point for a nozzle that must recover quickly after each shot, and 3 W/cm² is enough for slow-cycle commodity resins.

If the barrel runs above 400 °C, or the resin is glass-filled, step up to a ceramic heater band instead. Ceramic insulation tolerates higher surface temperatures and does not absorb moisture the way mica can.

Send us the nozzle OD, width, voltage and wattage and we will confirm the drawing before production. Non-standard diameters and cut-to-width bands are normal work for us, not exceptions.

Related

Other components in this range

View category

Need this part matched to your press?

Send the machine model and the resin. We confirm geometry, material and surface treatment before quoting.

Mica Nozzle Band Heaters — Specifications Quoted to confirmed specs