Dongguan International Technology Transfer Center, 124 Dongbao Road, Dongcheng District, Dongguan, China
Request a quote
Mica Barrel Heater Bands — Zone Setup
Mica Barrel Heater Bands

Mica Barrel Heater Bands — Zone Setup

Mica barrel heater bands for injection and extrusion machines: 60-400 mm ID, 40-200 mm width, 500-3000 W per zone, with terminal boxes and thermocouple options.

Sourced to the machine you actually run

Give us the machine model, tonnage or the space it has to fit. We confirm the exact unit, controls and options before quoting.

Quoted to confirmed specs

Engineering review Monday to Saturday. Send the machine model and the output you need — the reply carries price, scope and delivery.

Email engineering

Not sure which size fits? Send the machine model or a photo of the existing unit and we will match it.

Details

Specification & application

Barrel heater bands wrap the feed, compression and metering zones of an injection or extrusion barrel. Compared with nozzle bands they are wider, higher powered, and usually supplied with a protective terminal box because they operate in the busiest part of the machine.

Typical zone configuration

ZoneWidthPowerNotes
Feed zone60 - 120 mm800 - 2000 WOften water cooled underneath
Compression zone80 - 160 mm1200 - 3000 WHighest heat demand
Metering zone60 - 120 mm800 - 2000 WPaired with thermocouple
Nozzle25 - 60 mm150 - 600 WSee nozzle band heaters

Build options

  • Inside diameter 60 - 400 mm, made to the barrel OD
  • 304 stainless sheath, optional aluminized steel for faster warm-up
  • Terminal box with ceramic block, IP20 or splash-resistant
  • Built-in type J or K thermocouple, or a separate bayonet fitting
  • Two-piece hinged construction for retrofits where the barrel cannot be unbolted
  • Earth stud and high-temperature lead wire as standard

Why bands fail early

Almost every premature failure we see has one of three causes. Resin or purging compound has run down inside the band and carbonised, shorting the element. The band was clamped over a corroded or scaled barrel, so contact is poor and the element overheats locally. Or the lead wire was routed against a hot surface and the insulation hardened and cracked. All three are installation issues, not manufacturing defects, and all three are avoidable.

Pair these bands with barrel blankets to cut radiant loss, and check zone wiring against the hot runner control systems section if you run a manifold.

Related

Other components in this range

View category

Need this part matched to your press?

Send the machine model and the resin. We confirm geometry, material and surface treatment before quoting.

Mica Barrel Heater Bands — Zone Setup Quoted to confirmed specs