Dongguan International Technology Transfer Center, 124 Dongbao Road, Dongcheng District, Dongguan, China
Request a quote
Injection Molding Machine Selection Guide
Injection Molding Machines

Injection Molding Machine Selection Guide

How to specify an injection molding machine: clamp tonnage, shot size, tie bar spacing, platen size and screw diameter, with worked selection rules.

Sourced to the machine you actually run

Give us the machine model, tonnage or the space it has to fit. We confirm the exact unit, controls and options before quoting.

Quoted to confirmed specs

Engineering review Monday to Saturday. Send the machine model and the output you need — the reply carries price, scope and delivery.

Email engineering

Not sure which size fits? Send the machine model or a photo of the existing unit and we will match it.

Details

Specification & application

Machine selection goes wrong in one of two directions: buying clamp tonnage that is never used, or buying a machine whose tie bar spacing will not accept next year's mold. Both are avoidable with four numbers.

The four numbers that decide the machine

ParameterRule of thumb
Clamp tonnageProjected area (cm²) x cavity pressure (kg/cm²) / 1000, plus 10 - 20% margin
Shot sizePart + runner weight should sit at 25 - 70% of rated shot capacity
Tie bar spacingMold width + 50 mm minimum clearance
Daylight and strokeMold height + part depth + 30 mm for take-out

Tonnage guidance by part

  • Thin-wall packaging: 300 - 500 kg/cm² cavity pressure, high injection rate
  • General technical parts: 400 - 600 kg/cm²
  • Thick sections and low-MFI engineering resins: 600 - 800 kg/cm²
  • Add tonnage for long flow paths and for cold molds

Clamp types

Toggle machines are fast and energy efficient for high-volume, single-mold work. Two-platen machines give a smaller footprint and easier mold access on large tonnage. Hydraulic machines remain common where core pulls and complex sequences dominate. Servo hydraulic and all-electric drives reduce energy per shot substantially, and on a three-shift operation that difference usually pays back the price premium within two to three years.

The machine is only half the cell. Budget for a dryer, chiller and granulator, a conveyor, and the screw and barrel that suits the resin.

Related

Other components in this range

View category

Need this part matched to your press?

Send the machine model and the resin. We confirm geometry, material and surface treatment before quoting.

Injection Molding Machine Selection Guide Quoted to confirmed specs