Dongguan International Technology Transfer Center, 124 Dongbao Road, Dongcheng District, Dongguan, China
Request a quote
Ceramic Heater Bands for High-Temperature Zones
Ceramic Heater Bands

Ceramic Heater Bands for High-Temperature Zones

Ceramic insulated heater bands rated to 650 C with watt densities up to 7 W/cm2, for engineering resins, glass-filled compounds and high temperature nozzles.

Sourced to the machine you actually run

Give us the machine model, tonnage or the space it has to fit. We confirm the exact unit, controls and options before quoting.

Quoted to confirmed specs

Engineering review Monday to Saturday. Send the machine model and the output you need — the reply carries price, scope and delivery.

Email engineering

Not sure which size fits? Send the machine model or a photo of the existing unit and we will match it.

Details

Specification & application

Ceramic heater bands replace the mica core with interlocking ceramic segments that hold the resistance wire in a grooved channel. The result is a heater that runs hotter, recovers faster and does not absorb moisture — the three failure modes that send mica bands back for replacement.

Specifications

ParameterTypical range
Inside diameter30 mm - 300 mm
Band width30 mm - 120 mm
Maximum sheath temperature600 - 650 °C (1110 - 1200 °F)
Watt densityup to 7 W/cm²
Sheath material304 or 321 stainless steel, aluminized option
InsulationCeramic segments, moisture resistant
TerminationCeramic terminal block, screw or lead wire

When ceramic beats mica

  • Barrel or nozzle temperatures above 400 °C
  • Engineering resins: PEEK, PPS, PEI, PSU, high-temperature PA
  • Glass or mineral filled compounds that erode mica board
  • Machines that sit idle for days and are then restarted — ceramic does not soak up humidity
  • High watt density zones where a mica band would run at its limit

Installation

Clamp evenly and check the gap all the way round; a ceramic band that only touches on one side will fail there. Do not overtighten — the segments are brittle. Use the supplied clamping screw and torque it by hand, then re-check after the first heat cycle. Keep resin drool off the ceramic surface, and never wrap a failed band in aluminum foil as a temporary fix; it changes the heat balance and usually takes the thermocouple with it.

For lower temperature work where budget matters more than headroom, see mica nozzle band heaters.

Related

Other components in this range

View category

Need this part matched to your press?

Send the machine model and the resin. We confirm geometry, material and surface treatment before quoting.

Ceramic Heater Bands for High-Temperature Zones Quoted to confirmed specs